| Operating And Cleaning Procedure For Bopp Taper Machine |
1.0 OBJECTIVE: 1.1 To lay down a procedure for Operating And Cleaning Procedure For Bopp Taper Machine. 2.0 SCOPE: 2.1 This procedure is applicable for the BOPP Taper Machine. 3.0 RESPONSIBILITY: 3.1 Trained operator shall be responsible for operating and cleaning the machine as per the procedure mentioned in this SOP. 3.2 Production Officer / Supervisor shall be responsible for implementation of the procedure as per this SOP. 3.3 Production Head shall be responsible for compliance of procedure as per SOP. To read this sop Click here SOP for Cleaning, Operation and usage of dynamic pass box. 4.0 PROCEDURE: 4.1 Operating Procedure 4.1.1 Switch on the electric supply from the main. 4.1.2 Then switch ‘ON’ the power supply of BOPP taper machine. 4.1.3 Adjust the gap as per the requirement of the product. 4.1.4 Load the BOPP tape on the machine on upper and bottom side of the machine. 4.1.5 Record the product details in Machine Log Book as per Annexure XXX. 4.1.6 After completion of activity affix status label on the machine with detail of last product. 4.2 Cleaning Procedure 4.2.1 Switch “OFF” the machine by operating switch on panel of machine and from main switch. 4.2.2 Clean the external surface using clean cotton duster or with wet cotton duster. 4.2.3 Wipe all the parts with cleaned dry cotton duster. 4.2.4 Destroy the status label of the previous product. 4.2.5 Make new label after cleaning of the machine. 4.2.6 Stretch wrap the machine if machine is not in use 4.2.7 Take line clearance by IPQA as and when required. 4.2.8 Affix the status label on the machine. 5.0 ABBREVIATIONS 5.1 SOP : Standard Operating Procedure 5.2 BOPP : Bioxially Oriented Polyproplene 5.3 IPQA : In process Quality Assurance |
