Table of Contents
1.0 OBJECTIVE:
1.1 To lay down a procedure for Maintenance of Pumps.
2.0 SCOPE:
2.1 This procedure is applicable for the pumps.
3.0 RESPONSIBILITY:
3.1 Preventive Maintenance Procedure: Concerned Technician.
3.2 Implementation of Preventive maintenance Procedure: Officer Engineering.
3.3 Compliance of Preventive Maintenance Procedure :Head of Engineering Department
4.0 ABBREVIATIONS
4.1 SOP : Standard Operating Procedure
4.2 ppm : Parts Per Million
4.3 CC NO : Change Control Number
To Read this SOP Click Here SOP for Cleaning Operation and Qualification of incubator.
5.0 PROCEDURE:
5.1 Disconnect power supply to the required Pump and hang the Preventive maintenance display board.
5.2 Check and ensure that there is no leakage for pumps.
5.3 Check and ensure the couplings and coupling bush is in good condition.
5.4 Check visually all the bearing and bearing housing.
5.5 Clean the contactors carefully without damaging any important parts.
5.6 Check the current in all three phases; it should be lesser than the rated current
5.7 Record all the observation in the Preventive Maintenance Checklist of respected areas and system.